vovaima.blogg.se - Schumacher battery charger 12v

#Schumacher battery charger 12v manual

See Operating Instructions for length of charge information.įOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE.When disconnecting charger, turn switches to off, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery terminal.Connect to a heavy gauge metal part of the frame or engine block. Do not connect clip to carburetor, fuel lines, or sheet-metal body parts. Connect POSITIVE (RED) clip to vehicle chassis or engine block away from battery. For positive-grounded vehicle, connect NEGATIVE (BLACK) clip from battery charger to NEGATIVE (NEG, N, –) ungrounded post of battery.Connect NEGATIVE (BLACK) clip to vehicle chassis or engine block away from battery. For negative-grounded vehicle, connect POSITIVE (RED) clip from battery charger to POSITIVE (POS, P, +) ungrounded post of battery.If positive post is grounded to the chassis, see (6.6).

If negative post is grounded to chassis (as in most vehicles), see (6.5).

Determine which post of battery is grounded (connected) to the chassis.

POSITIVE (POS, P, +) battery post usually has larger diameter than NEGATIVE (NEG, N,–) post.

Stay clear of fan blades, belts, pulleys, and other parts that can cause injury to persons.

Position AC and DC cords to reduce risk of damage by hood, door, or moving engine part.

TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY: WARNING: A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION.

Attach clips to battery and chassis, as indicated in sections 6 and 7.įOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE.

Connect and disconnect DC output clips only after setting any charger switches to “off” position and removing AC cord from electric outlet.

Do not set a battery on top of charger.

Do not operate charger in a closed-in area or restrict ventilation in any way.

Never allow battery acid to drip on charger when reading electrolyte specific gravity or filling battery.

Never place charger directly above battery being charged gases from battery will corrode and damage charger.

Locate charger as far away from battery as DC cables permit.

If charger has adjustable charge rate, charge battery initially at lowest rate.

#Schumacher battery charger 12v manual

Determine voltage of battery by referring to car owner’s manual and make sure that output voltage selector switch is set at correct voltage.Study all battery manufacturer’s specific precautions while charging and recommended rates of charge.For a battery without removable cell caps, such as valve regulated lead acid batteries, carefully follow manufacturer’s recharging instructions. Add distilled water in each cell until battery acid reaches level specified by battery manufacturer.Be careful to keep corrosion from coming in contact with eyes. Be sure area around battery is well ventilated while battery is being charged.Make sure all accessories in the vehicle are off, so as not to cause an arc. If necessary to remove battery from vehicle to charge, always remove grounded terminal from battery first.

Owner 's Manual for Battery Charger PREPARING TO CHARGE GROUNDING AND AC POWER CORD CONNECTIONS.FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE.FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE.Schumacher SC1304 15A 6V/12V Fully Automatic Battery Charger - Use Manual - Use Guide PDF.